Filter
Top Products
DEFINITY Enterprise Communications Server Release 6
Maintenance for R6vs/si
555-230-127
Issue 1
August 1997
Maintenance Object Repair Procedures
Page 10-742ISDN-SGR (ISDN-PRI Signaling Group)
10
Figure 10-57. Secondary Signaling Link Hardware Check for PRI over PACCON
(Test #639)
Table 10-245. TEST #639 Secondary Signaling Link Hardware Check
Error
Code
Test
Result Description/ Recommendation
ABORT Internal system error
1. Retry the command at 1minute intervals a maximum of 5 times.
1132 ABORT The Secondary D-channel is not administered for this Signaling Group.
This is a NORMAL ABORT. Only a Primary D-channel must be
administered for a Signaling Group.
4 FAIL There is a problem with the Processor Interface Link. No DS1 ISDN Trunk
(B-channel) or Wideband PRI Endpoint calls can be made until the
problem is resolved.
1. Display the Communication-Interface Links Form via the display
communication-interface command to determine which link is down
(find the one that matches the DS1 Interface circuit pack on which this
ISDN-PRI Signaling Link Port resides) and then refer to the PI-LINK
Processor Interface Link Maintenance documentation.
8 FAIL There is a problem with the DS1/UDS1 Interface circuit pack or the
ISDN-PRI Secondary Signaling channel (D-channel). No ISDN Trunk
(B-channel) or Wideband PRI Endpoint calls can be made until the
problem is resolved.
1. Refer to the DS1/UDS1 circuit pack and the ISDN-PRI Signaling
channel (ISDN-LNK/ISDN-PLK) Maintenance documentation.
PASS The basic physical connectivity of the Signaling Group’s Secondary
D-channel is intact and functional. Try this test repeatedly to ensure the link
is up and to uncover any transitory problems.
Continued on next page
Packet Bus
To far end
switch hardware
Processor
(TN786)
Packet
Control
Circuit
Pack
(TN778)
UDS1
Interface
Circuit
Pack
(TN464*)
*TN464 C or later