Filter
Top Products
DEFINITY Enterprise Communications Server Release 6
Maintenance for R6vs/si
555-230-127
Issue 1
August 1997
Maintenance Object Repair Procedures
Page 10-1248TAPE (Tape Unit) [G3iV1.1-286]
10
9012 Tape already in use. 1. If the Tape Unit is in use (that is, the yellow
LED on the tape drive is on and there is
tape cartridge motion), wait until the first
request is complete. If there does not
appear to be tape motion and/or the
yellow LED on the tape drive is not on,
go to next step.
2. Retry the test tape command at
one-minute intervals a maximum of five
times. If the command continues to
abort, escalate the problem.
9013 Tape drive self-test failed. 1. Follow the instructions provided in the
‘‘
Tape Maintenance and Repair
Procedures’’ section.
2. If the problem still exists, escalate the
problem.
9015 Test detected hardware
failure.
9017 Could NOT reset the tape
drive.
9020
!
WARNING:
The tape cartridge is
starting to wear, but it is
still functional.
9023 Write-protected tape. 1. Disable the write-protect switch on the tape
cartridge.
2. Check the power by performing Step 1 of
the ‘‘
Tape Maintenance and Repair
Procedures’’ section.
3. If the problem still exists, escalate the
problem.
Table 10-433. Table A: Tape Unit Aux Data Table — Continued
Aux Data/
Error Codes Explanation Strategy
Continued on next page