Filter
Top Products
DEFINITY Enterprise Communications Server Release 6
Maintenance for R6vs/si
555-230-127
Issue 1
August 1997
Error Messages
Page A-3busyout cdr-link
A
If the specified board is part of the DCS link, the board cannot be busied out unless the
link itself is busied out first. If the DCS link is not busied out, the following message will
be displayed:
Must first busyout SCI link
If the specified board is an EI board and it is part of the active link, the following
message will be displayed:
Illegal Command for active object; use ’set’ to switch to standby
If a busyout is attempted on an invalid board in the service slot, the following message is
displayed:
Board invalid
If the command entered is in conflict with another currently executing command, then a
message will be displayed showing the login id of the conflicting user and the conflicting
command. The message is as follows:
’login id’:’command’ has a command conflict
If during the execution of a command a resource problem occurs that requires the user
to restart the command, then the following message will be displayed:
Command resources busy; Press CANCEL to clear, and then resubmit
If all of the available maintenance resources are currently in use, then the following
message will be displayed:
All maintenance resources busy; try again later
busyout cdr-link
This command will busyout a maintenance object associated with the specified call
detail recording (cdr)-link.
Help Messages
If the system technician presses HELP after entering "busyout cdr-link," the following
message will be displayed:
primary secondary
Error Messages
If the command entered is in conflict with another currently executing command, then a
message will be displayed showing the login id of the conflicting user and the conflicting
command. The message is as follows:
’login id’:’command’ has a command conflict