Filter
Top Products
DEFINITY Enterprise Communications Server Release 6
Maintenance for R6vs/si
555-230-127
Issue 1
August 1997
Error Messages
Page A-75set expansion-link
A
Error Messages
If there is another tape activity currently running on the system, then the following
message will be displayed:
A tape command is active;
this command is not allowed at this time
If the user chooses that save be done on the standby processor, and the standby
processor is inaccessible, then the following message will be displayed:
Cannot access the standby SPE at this time
If the command entered is in conflict with another currently executing command, then a
message will be displayed showing the login id of the conflicting user and the conflicting
command. The message is as follows:
’login id’:’command’ has a command conflict
set expansion-link
Help Messages
If the system technician presses HELP after entering "set expansion-interface," the
following message will be displayed:
Enter board location: [cabinet(1-3)];carrier(A-E);slot(0-20)
Error Messages
If the format of the specified expansion interface circuit pack is invalid, the following
message will be displayed:
Port/Board invalid
If the link associated with the entered EI location is already active, the following message
will be displayed:
EXP-INTF is already on active link
If the specified expansion interface is not configured in the system, the following
message will be displayed:
Board not assigned
If the specified expansion interface is already the active link, the following message will
be displayed:
EXP-INTF is already on active link