Filter
Top Products
DEFINITY Enterprise Communications Server Release 6
Maintenance for R6vs/si
555-230-127
Issue 1
August 1997
Maintenance Object Repair Procedures
Page 10-1296TBRI-PT (TN2185 ISDN Trunk-Side BRI Port)
10
The Deactivated state indicates a problem with the TBRI-BD circuit pack. When
in this state, the Level 1 interface is not active, and an idle signal is transmitted to
the channels or that Layer 1 was deactivated by the switch. When an TBRI-PT
port is placed in the out-of-service state, Level 1 is also put into the Deactivated
state. This could be due either to the system detecting a fault with the port or to a
busyout port PCSSpp request.
Table 10-448. TEST #1242 Level 1 Status Inquiry
Error
Code
Test
Result Description/ Recommendation
1187 ABORT The board or port may be busied out.
1. Look in the Error Log for Error Type 18 (port busied out) for this port
and TBRI-BD (board busied out). If this error type is present for
TBRI-PT only, then release the port with the release port PCSSpp
command and run the test again. If the error is present for both
TBRI-BD and TBRI-PT, then release the board with the release board
PCSS command and run the test again.
NOTE:
When you release a port, you release all ports associated with it. If
certain ports still need to be busied out, use the release port
PCSSpp command to busy them out.
2. Make sure the terminal is connected.
3. Retry the command at 1-minute intervals a maximum of 5 times.
2000 ABORT Response to the test was not received from the circuit pack within the
allowable time period.
1. If the test aborts repeatedly a maximum of 5 times, reset the circuit
pack with the busyout board PCSS and reset board PCSS
commands.
2. If the test aborts again, replace the circuit pack.
2012 ABORT Internal system error
2100 ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals a maximum of 5 times.
Continued on next page