Filter
Top Products
DEFINITY Enterprise Communications Server Release 6
Maintenance for R6vs/si
555-230-127
Issue 1
August 1997
Maintenance Commands and Trouble-Clearing Aids
Page 8-229status bri-port
8
Table 8-3. Status BRI-Port Command Interpretation
Endpoint
Types
TEI
Range Layer 2 State
Voice
Extension
Service
SPID Description / Recommendation
ASAI, BRI 0-126 Assigned blank blank Transitory state for BRI endpoints
and ASAI adjuncts. The switch
attempts link establishment.
1. Check endpoints and wiring by
following SPID Facility Test
Procedures described in the
BRI-SET (ISDN-BRI Set/ASAI
Adjunct) Maintenance
documentation.
2. Verify repairs by executing the
status bri-port PCSSpp
command. Determine that L2
state of the signaling link is
“L3-Established” for ASAI
adjuncts and BRI endpoints
supporting MIM (management
information messages)
initialization, and “Established”
for fixed TEIBRI endpoints and
automatic TEIBRI endpoints not
supporting MIM initialization.
NOTE:
A MIM is a level-3 message
that conveys management
and maintenance information
between communications
systems and BRI terminals.
ASAI 0-63 Established blank blank Transitory state for ASAI adjuncts.
ASAI signaling is connects at Layer
2. Layer 3 Restart procedure does
not complete between switch and
adjunct.
1. Check the adjunct by following
the manufacturer’s
recommended repair
procedures.
2. Verify repairs by executing the
status bri-port PCSSpp
command. Determine that the
L2 state of the signaling link is
L3-Established.
Continued on next page