Filter
Top Products
DEFINITY Enterprise Communications Server Release 6
Maintenance for R6vs/si
555-230-127
Issue 1
August 1997
Error Messages
Page A-79set tdm
A
If during the execution of a command a resource problem occurs that requires the user
to restart the command, then the following message will be displayed:
Command resources busy;
Press CANCEL to clear, and then resubmit
If all of the available maintenance resources are currently in use, then the following
message will be displayed:
All maintenance resources busy; try again later
Can not set synchronization to standby tone clock circuit pack.
Cannot set synchronization to standby tone/clock board.
set tdm
Help Messages
If the system technician presses HELP after entering "set tdm," the following message will
be displayed:
Enter ’port-network’, port network number (1-3),
’bus’, bus (’a’ or ’b’); [’override’]
Error Messages
If the technician enters "bus" before "port-network," the following message will be
displayed:
’bus’ is an invalid identifier; please press
HELP
If the technician does not enter all digits for the port-network number, the following
message will be displayed:
Entry must be all digits
If the technician enters a bus other than A or B, the following message will be displayed:
Identifier invalid
If the technician enters a Port Network number that is not administered, the following
message will be displayed:
Port Network number not assigned
If the command entered is in conflict with another currently executing command, then a
message will be displayed showing the login id of the conflicting user and the conflicting
command. The message is as follows:
’login id’:’command’ has a command conflict