Filter
Top Products
DEFINITY Enterprise Communications Server Release 5
Maintenance and Test for R5vs/si
555-230-123
Issue 1
April 1997
Maintenance Object Repair Procedures
Page 10-120ANN-PT (Announcement Port)
10
■ release circuit pack using the release board PCSS command
140AY Channel Sanity Inquiry Test (#222)
The Angel keeps a sanity status bit for each of the 16 channels on the 140AY
device. This test queries the Angel to determine the status for a particular
channel. If a channel is insane, that implies that announcements cannot be
played back on that channel.
Table 10-41. TEST #222 140AY Channel Sanity Inquiry Test
Error
Code
Test
Result Description/ Recommendation
2000 ABORT Response to the test request was not received within the
allowable time period.
2100 ABORT Could not allocate the necessary system resources to
run this test.
ABORT Internal System Error.
1. Retry the command at one-minute intervals a
maximum of five times.
2. If the test continues to abort, escalate the problem.
FAIL Test failed. Announcements cannot be played back over
this port.
1. Reset the circuit pack via the reset board PCSS
command and then run this test again. If the test
continues to fail, replace the circuit pack (see
Warning).
2. If there are recurring alarms on this port caused by
this test failing, replace the circuit pack even if Step
1 works (see Warning).
!
WARNING:
Replacing the circuit pack results in loss of
integrated announcements. Refer to "General
Notes" near the beginning of this Maintenance
procedure.
Continued on next page