Filter
Top Products
DEFINITY Enterprise Communications Server Release 5
Maintenance and Test for R5vs/si
555-230-123
Issue 1
April 1997
Maintenance Object Repair Procedures
Page 10-315CO-DS1 (DS1 CO Trunk)
10
and conference the tones together. The resulting signal is then measured by a
tone detector port. If the level of the tone is within a certain range, the test
passes.
Table 10-89. TEST #7 Conference Circuit Test
Error
Code
Test
Result Description/ Recommendation
ABORT System resources required for this test are not available.
1. Retry the command at one-minute intervals a
maximum of five times.
2. If the test continues to abort, escalate the problem.
1000 ABORT The test was aborted. System resources required to run
this test were not available. The port may be busy with a
valid call. Use the display port PCSSpp command to
determine the trunk group/member number of the port.
Use the status trunk command to determine the service
state of the port. If the service state indicates that the
port is in use, then the port is unavailable for certain
tests. You must wait until the port is idle before retesting.
1. If the port status is active but the port is not in use
(no calls), check the error log for error type 1025
(see the error log table for a description of this error
and required actions). The port may be locked up.
2. If the port status is idle, retry the command at
1-minute intervals for a maximum of 5 times.
3. If the test continues to abort, escalate the problem.
1002 ABORT The test was aborted. The system could not allocate
time slots for the test. The system may be under heavy
traffic conditions, or it may have time slots out of service
due to TDM-BUS errors. Refer to the TDM-BUS (TDM
bus) maintenance documentation to diagnose any
active TDM-BUS errors.
1. If the system has no TDM-BUS errors and is not
handling heavy traffic and the port status is idle,
retry the command at 1-minute intervals for a
maximum of 5 times.
2. If the test continues to abort, escalate the problem.
Continued on next page