Filter
Top Products
DEFINITY Enterprise Communications Server Release 5
Maintenance and Test for R5vs/si
555-230-123
Issue 1
April 1997
Maintenance Object Repair Procedures
Page 10-428DID-DS1 (DS1 DID Trunk)
10
DID-DS1 (DS1 DID Trunk)
The DID-DS1 trunk provides a digital DID trunk from a CO switch into the system
through a DS1 link. A 24 channel DS1 link can support up to 24 DID-DS1 trunk
calls simultaneously. A 32 channel DS1 link [G3iV2-386] can support up to 30
DID-DS1 trunk calls simultaneously. A DID-DS1 trunk can be used for both voice
and data communications with appropriate DS1 signaling mode (for example,
common channel signaling). Only the TN767 and TN464 [G3iV2-386] DS1
Interface circuit packs support the DID-DS1 trunk call processing signalings,
wink-start, and immediate-start.
DID-DS1 trunk maintenance provides a means to maintain a DID trunk on a port
of DS1 Interface circuit pack. Information included covers the in-line errors log,
initialization tests, periodic tests, system technician demand tests, and alarms
escalation and elimination. Two trunk service states are specified in the DID-DS1
trunk maintenance. They are:
out-of-service
, the trunk is in a deactivated state
and can’t be used for incoming calls;
in-service
, the trunk is in an activated state
and can be used for incoming calls. If the DS1 Interface circuit pack is
out-of-service, then all trunks on the DS1 Interface circuit pack are put into
out-of-service state and a Warning alarm is raised.
1. A major alarm on a trunk indicates that alarms on these trunks are not downgraded by
the set options command and that at least 75 percent of the trunks in this trunk group
are alarmed.
MO Name As
It Appears in
Alarm Log
Alarm
Level
Initial System
Technician
Command to Run Full Name of MO
DID-DS1 MAJOR
1
test trunk
<grp>/<mbr> l
Direct Inward Dial Trunk
DID-DS1 MINOR test trunk
<grp>/<mbr> l
Direct Inward Dial Trunk
DID-DS1 WARNING test trunk
<grp>/<mbr>
Direct Inward Dial Trunk