Filter
Top Products
DEFINITY Enterprise Communications Server Release 5
Maintenance and Test for R5vs/si
555-230-123
Issue 1
April 1997
Maintenance Commands and Trouble-Clearing Aids
Page 8-76clear interface
8
Synopsis
clear interface location
Permissions
The following default logins may execute this command: system technician,
inads, init.
Examples
clear interface 01a1
clear interface 01a2
clear interface a2
Description
The clear interface command causes all counter values maintained by the
Processor Interface (PI) circuit pack to be reinitialized. These counters display
via the status interface command which is for use in the development
environment only. The PI circuit pack is a front end processor implementing the
packet layer and link layer of the BX.25 protocol, and the ISDN procedure-D
protocol.
Defaults
None
Parameters
Help Messages
If HELP is pressed after entering "clear interface," the following message is
displayed:
Enter location: [cabinet(1)], carrier(A-B), pos(1-2)
Error Messages
If the specified carrier is not the active PE, the following message is displayed:
Command must be executed from active SPE
location The location (cabinet-carrier-position) of the processor interface. The
position determines which processor interface circuit pack will be
cleared. A position of 1 is the first processor interface in the carrier,
while a position of 2 is the second processor interface in the carrier.