Filter
Top Products
DEFINITY Enterprise Communications Server Release 5
Maintenance and Test for R5vs/si
555-230-123
Issue 1
April 1997
Routine Maintenance Procedures
Page 5-60System Features
5
by call) service type, then the Testcall Service field on Trunk Group
Administration Form must have been administered also.
To initiate an outgoing ISDN-PRI test call in the asynchronous method, issue the
following command:
test isdn-testcall <grp>/<mbr> [minutes]
This command enables you to specify a specific the trunk on which to originate
the ISDN-PRI test call.
NOTE:
The optional qualifier can also be used that specifies in minutes the
duration of the test call. If no duration is specified, the default duration is
used which is 8.4 or 9.6 seconds. The qualifier "minutes" accepts the
numeric values one through 120 (that is, two hours = 120 minutes).
Screen 5-6
shows a typical response to the test isdn-testcall command:
Screen 5-6. Typical Response to Test ISDN-Testcall Command
The meaning of the information displayed in response to the above command is
described in the following list.
■ Port: The port address (PCSSpp) is the port network number, carrier
designation, slot, and circuit of the maintenance object under test.
■ Maintenance Name: The type of maintenance object tested.
■ Test Number: The actual test that was run.
■ Test Results: Indicates whether the test passes, fails, or aborts.
■ Error Code: Additional information about the results of the test. (See the
ISDN Trunk Maintenance documentation for details.)
The functions of the clear, list, and status commands associated with the ISDN
Testcall are summarized in the following list. For more detailed information, refer
to the appropriate sections as directed.
test isdn-testcall
Port Maintenance Name Test Number Test Result Error Code
1B1501 ISDN-TRK 258 PASS