Filter
Top Products
DEFINITY Enterprise Communications Server Release 5
Maintenance and Test for R5vs/si
555-230-123
Issue 1
April 1997
Maintenance Object Repair Procedures
Page 10-1254SPE-SELEC (SPE Select Switch)
10
Table 10-390. TEST #278 SPE Select Query Test
Error
Code
Test
Result Description/ Recommendation
1000 ABORT System resources required to run this test are not available.
2000 ABORT Response to the test request was not received within the allowable time
period.
2033 ABORT Internal system error
1. Retry the command at 1-minute intervals a maximum of 5 times.
1 FAIL The switch currently selects SPE-A active.
2 FAIL The switch currently selects SPE-B active.
1. Move the switch to the AUTO position.
2. Rerun the test.
3 FAIL The Duplication Interface circuit pack is not present or not functioning.
1. Resolve all alarms logged against the Duplication Interface circuit pack
(DUPINT).
2. Rerun the test.
PASS The Duplication Interface circuit pack has reported that the SPE Select Switch
is in the AUTO position.
1. If a visual inspection shows the SPE Select Switch is not in the AUTO
position, then resolve all alarms logged against Duplication Interface
circuit pack (DUPINT).
2. Repeat the test.
3. If Duplication Interface circuit pack B is being tested and a visual
inspection shows that the switch is not in the normal position, Duplication
Interface circuit pack A may be incorrectly reporting the state of
SPE-Select Switch B. Replace Duplication Interface circuit pack A, and
rerun the test.
Continued on next page