Filter
Top Products
DEFINITY Enterprise Communications Server Release 5
Maintenance and Test for R5vs/si
555-230-123
Issue 1
April 1997
Maintenance Object Repair Procedures
Page 10-436DID-DS1 (DS1 DID Trunk)
10
Table 10-122. TEST #7 Conference Circuit Test
Error
Code
Test
Result Description/ Recommendation
ABORT Could not allocate the necessary system resources to run this
test.
1. Retry the command at one-minute intervals a maximum of five
times.
2. If the test continues to abort, escalate the problem.
1000 ABORT System resources required to run this test were not available. The
port may be busy with a valid call. Use the display port
UUCSSpp command to determine the trunk group/member
number of the port. Use the status trunk command to determine
the service state of the port. If the service state indicates that the
port is in use, then the port is unavailable for certain tests. You
must wait until the port is idle before retesting.
1. If the port status is active but the port is not in use (no calls),
check the error log for error type 1025 (see the Error Log
table for a description of this error and required actions). The
port may be locked up.
2. If the port status is idle, retry the command at 1 minute
intervals for a maximum of 5 times.
3. If the test continues to abort, escalate the problem.
1002 ABORT The system could not allocate time slots for the test. The system
may be under heavy traffic conditions, or it may have time slots
out of service due to TDM-BUS errors. Refer to the TDM-BUS
(TDM bus) Maintenance documentation to diagnose any active
TDM-BUS errors.
1. If the system has no TDM-BUS errors and is not handling
heavy traffic and the port status is idle, retry the command at
1 minute intervals for a maximum of 5 times.
2. If the test continues to abort, escalate the problem.
Continued on next page