Filter
Top Products
DEFINITY Enterprise Communications Server Release 5
Maintenance and Test for R5vs/si
555-230-123
Issue 1
April 1997
Maintenance Object Repair Procedures
Page 10-1602UDS1-BD (UDS1 Interface Circuit Pack)
10
1005 ABORT CSU Equipment Loopback Test cannot be executed in
the current configuration. To run this test, the
Near-End
CSU Type
field on the DS1 circuit pack administration
form must be set to
integrated
and the "Bit Rate" field
must be set to "1.544" (24-channel operation).
1. Use the change ds1 PCSS command to set the
Near-End CSU Type
field on the DS1 circuit pack
administration form to
integrated
, and/or change the
"Bit Rate" field to "1.544" if the board is to be used in
24-channel configuration.
2. Retry the
test ds1-loop PCSS
ds1/csu-loopback-tests
command.
3. If the test continues to abort, escalate the problem.
1015 ABORT Ports on the UDS1 Interface circuit pack have not been
busied out to out-of-service.
1. Enter the busyout board PCSS command to put all
trunks or ports of the UDS1 Interface circuit pack
into the out-of-service state.
2. Retry the command.
3. If the test continues to abort, escalate the problem.
Table 10-470. TEST #1210 CSU Equipment Loopback Test — Continued
Error
Code
Test
Result Description/ Recommendation
Continued on next page