Filter
Top Products
DEFINITY Enterprise Communications Server Release 5
Maintenance and Test for R5vs/si
555-230-123
Issue 1
April 1997
Maintenance Object Repair Procedures
Page 10-1012PDMODULE, TDMODULE (Data Module)
10
2. With the port still in loop around mode, the S channel Loop Around Test is
performed next. This test consists of sending four different transparent
patterns to the on-board microprocessor, receiving them back, and
comparing them.
3. The third test is a Loop Around Test for the secondary (alternate) channel.
It is not performed for data modules since this channel is not used by
MPDMs, MTDMs, and stand-alone DA’s [G3iV2-386].
4. A Conference Test is done next for the primary channel. This test is the
same as the Analog Line Terminal/Port Conference Test (#6).
Only one value (Pass, Fail, or Abort) is generated as a result of four tests run. If
any test fails or aborts, the sequence is stopped.
Table 10-290. TEST #13 Information and Control Channel
Local Loop Test
Error
Code
Test
Result Description/ Recommendation
ABORT Internal System Error.
1. Retry the command at one-minute intervals a
maximum of five times.
2. If the test continues to abort, escalate the problem.
1000 ABORT System resources required to run test are not available.
Port may be busy with a valid call. Use display port
PCSSpp command to determine the data module
extension. Then use status data module command with
the extension number to determine the service state of
the data module. If the service state indicates that the
data module is in use, then port is unavailable for certain
tests. Wait until port is idle before retesting.
1. If the port status is idle, retry the command at
one-minute intervals a maximum of five times.
2. If the test continues to abort, escalate the problem.
1001 ABORT System resources required to run this test are not
available.
1. Retry the command at one-minute intervals a
maximum of five times.
2. If the test continues to abort, escalate the problem.
Continued on next page