Filter
Top Products
DEFINITY Enterprise Communications Server Release 5
Maintenance and Test for R5vs/si
555-230-123
Issue 1
April 1997
Maintenance Object Repair Procedures
Page 10-960M/T-ANL (Maintenance/Test Analog Port)
10
Hook State Inquiry (#566)
This test ensures that the Maintenance/Test Analog Port maintenance software
and call processing agree on the on-/off-hook status of the Maintenance/Test
Analog Port.
Table 10-276. TEST #566 Hook State Inquiry
Error
Code
Test
Result Description/ Recommendation
1 ABORT Switch hook audit timed out. No response was
received from the circuit pack for information about
the switch hook state.
1. Retry the command at 1 minute intervals a
maximum of 3 times.
2. If the test continues to abort, replace the circuit
pack and repeat the test.
3. If the test continues to abort, escalate the
problem.
2100 ABORT System resources required to run this test are not
available.
1. Retry the command at 1 minute intervals a
maximum of 3 times.
2. If the test continues to abort, escalate the
problem.
Any FAIL Internal System Error
1. Retry the command at 1 minute intervals a
maximum of 3 times.
2. If the test continues to fail reset the circuit pack via
the busyout board PCSS, reset board PCSS,
release board PCSS command sequence.
3. Retry the command at 1 minute intervals a
maximum of 3 times.
4. If the test continues to fail, escalate the problem.
PASS Call processing and Maintenance/Test Analog Port
maintenance software agree on the Maintenance/Test
Analog Port hook state.
Continued on next page