Filter
Top Products
DEFINITY Enterprise Communications Server Release 5
Maintenance and Test for R5vs/si
555-230-123
Issue 1
April 1997
Maintenance Object Repair Procedures
Page 10-1192PROCR (TN790 RISC Processor Circuit Pack)
10
Notes:
a. Refer to “PR-MEM” for a description of these tests.
b. There are Functional Memory Test errors against the Processor circuit
pack. This test is run only on the Standby SPE in a high or critical reliability
system. On other systems or on the Active SPE, the test is run only via a
reset system 4 command or a reset system 5 command.
c. Refer to “PR-MAINT” for a description of these tests.
Processor BOOTPROM Checksum Test (#80)
This test is a nondestructive test. This test computes the checksum of the
Processor’s bootstrap BOOTPROM. A failure indicates the BOOTPROM is
corrupt.
Table 10-367. Test #80 Processor BOOTPROM Checksum Test
Error
Code
Test
Result Description/ Recommendation
100 ABORT The test did not complete within the allowable time period.
1. Retry the command.
1029
2014
2015
2016
2017
2018
2020
2022
2024
2025
2051
ABORT Refer to STBY-SPE Maintenance documentation for a description of these
error codes.
2500 ABORT Internal system error
1. Retry the command.
FAIL The computed checksum did not match the BOOTPROM checksum. The
system may not continue to operate correctly. The system may fail at some
future date when the corrupted area the bootstrap BOOTPROM is
accessed.
1. Replace the Processor circuit pack.
PASS The computed checksum matched the BOOTPROM checksum. This part
of the Processor will continue to operate normally.
Continued on next page