Filter
Top Products
DEFINITY Enterprise Communications Server Release 5
Maintenance and Test for R5vs/si
555-230-123
Issue 1
April 1997
Maintenance Commands and Trouble-Clearing Aids
Page 8-571test ds1-loop
8
Help Messages
If the system technician presses HELP after entering "test ds1-loop" the following
message will be displayed:
Enter DS1 board location,
[’cpe-loopback-jack-test-begin [number-of-bits bit-pattern]’ or
’far-csu-loopback-test-begin’ or ’one-way-span-test-begin’ or
’end-loopback/span-test’ or ’inject-single-bit-error’ or
’ds1/csu-loopback-tests’]
Error Messages
If the format for the board location is incorrect, the following error message will
be displayed:
Port/Board invalid
If the EPN in which the specified board resides is not available, the following
message will be displayed:
EPN is not available
If the specified board is not inserted in the system, the following message will be
displayed:
Board not inserted
If the command entered is in conflict with another currently executing command,
then a message will be displayed showing the login id of the conflicting user and
the conflicting command. The message is as follows:
’login id’:’command’ has a command conflict
If during the execution of a command a resource problem occurs that requires
the user to restart the command, then the following message will be displayed:
Command resources busy; Press CANCEL to clear, and then resubmit
If all of the available maintenance resources are currently in use, then the
following message will be displayed:
All maintenance resources busy; try again later
If the "test ds1-loop" command is executed and the "Version" field on the
"system-parameters customer-options" form is not V5 or later, then the following
message will be displayed:
G3 Version must be V5 or later
If the "test ds1-loop" command is executed on a circuit pack other than TN464F
or TN767E or later DS1 board, then the following message will be displayed:
Command valid for TN464F or TN767E or
later release DS1 circuit packs