Filter
Top Products
DEFINITY Enterprise Communications Server Release 5
Maintenance and Test for R5vs/si
555-230-123
Issue 1
April 1997
Maintenance Object Repair Procedures
Page 10-1355TAPE (Tape Unit) [G3iV1.1-286]
10
NOTE:
This test does not check for tape cartridge data consistency, nor does it
check the integrity of every block on tape.
Tape Diagnostic Test (#66)
This test activates the diagnostic tests built into the Maintenance/Tape Processor
(MTP) firmware on the TN773 Processor circuit pack. The test verifies the basic
read/write capability of the tape drive and tape cartridge. Also, the test performs
controller/MTP hardware diagnostics.
The test reads from the tape and performs write verification testing by writing
data into a maintenance block and reading it back. It also performs a tape drive
head step check by advancing the tape drive head through all even streams on
the tape (streams 0 through 18) to make sure the head is operational.
The test does not test every data block on the tape.
Table 10-408. TEST #65 Tape Read/Write Test
Error
Code
Test
Result Description/ Recommendation
1029 to
1030
and
2011 to
2051
ABORT Refer to the STBY-SPE (Standby SPE) Maintenance
documentation for a description of these error codes.
9000’s ABORT
or FAIL
Refer to Table A in ‘‘
Tape Unit Aux Data/Error Codes
Tables’’ and follow the recommended repair strategy for
specific Aux Data.
Any
Others
ABORT
or FAIL
Refer to Table B in ‘‘
Tape Unit Aux Data/Error Codes
Tables’’ and follow the recommended repair strategy for
specific Aux Data.
PASS All tape hardware is in good working order. Passing this
test does not guarantee that every single data block on
the tape cartridge can be read or written to.
Continued on next page