Filter
Top Products
DEFINITY Enterprise Communications Server Release 5
Maintenance and Test for R5vs/si
555-230-123
Issue 1
April 1997
Maintenance Object Repair Procedures
Page 10-1518TSC-ADM (Administered Temporary Signaling Connections)
10
1146 ABORT The congestion just occurred in the network.
1. Issue the status tsc-administered command at
one-minute intervals a maximum of three times.
2. If congestion does not clear, disable and enable the
Administered TSC via the change sig-group
<group> command. To disable the Administered
TSC, display the (administration) Signaling Group
Form via the change sig-group <group> command
where <group> refers to the number of the signaling
group under which the suspect TSC is administered.
Change the Enable field to "n." To enable the
ADMTSC, change the "Enable" field to "y."
3. If congestion still does not clear, check the other
nodes in the network. If the congestion persists,
escalate the problem.
1147 ABORT The ADMTSC is being torn down.
1. Issue the status tsc-administered command at
one-minute intervals a maximum of three times.
2. If ADMTSC is still down, disable and enable the
ADM TSC via the change sig-group <group>
command. NOTE: To disable the ADMTSC, display
the (administration) Signaling Group Form via the
change sig-group <group> command where
<group> refers to the number of the signaling group
under which the suspect TSC is administered.
Change the Enable field to "n." To enable the
ADMTSC, change the "Enable" field to "y."
3. If the ADMTSC is still down, check the other nodes in
the network. If the ADMTSC is still down, escalate
the problem.
1148 ABORT The ADMTSC is enabled, but inactive (near-end).
1. Disable and enable the ADMTSC.
2. Reissue the test tsc-administered command.
3. If the ADMTSC is still inactive, check the other nodes
in the network.
Table 10-453. TEST #604 TSC Hartbeat Inquiry Test
Error
Code
Test
Result Description/ Recommendation
Continued on next page