Filter
Top Products
DEFINITY Enterprise Communications Server Release 5
Maintenance and Test for R5vs/si
555-230-123
Issue 1
April 1997
Maintenance Object Repair Procedures
Page 10-915MODEM-PT (Modem Pool Port)
10
1001 ABORT System resources required to run this test are not
available.
1. Retry the command at one minute intervals a
maximum of five times.
2. If the test continues to abort, escalate the problem.
1002 ABORT The system could not allocate time slots for the test. The
system may be under heavy traffic conditions or it may
have time slots out-of-service due to TDM-BUS errors.
Refer to TDM-BUS (TDM Bus) Maintenance
documentation to diagnose any active TDM-BUS errors.
1. If the system has no TDM-BUS errors and is not
handling heavy traffic, repeat the test at one minute
intervals a maximum of five times.
2. If the test continues to abort, escalate the problem.
1003 ABORT The system could not allocate a tone receiver for the
test. The system may be oversized for the number of
Tone Detectors present or some Tone Detectors may be
out-of-service.
1. Look for TTR-LEV errors in the Hardware Error Log. If
present, refer to TTR-LEV (TTR Level) Maintenance
documentation.
2. Look for TONE-PT errors in the Hardware Error Log.
If present, refer to TONE-PT (Tone Generator)
Maintenance documentation.
3. If neither condition exists, retry the test at one minute
intervals a maximum of five times.
4. If the test continues to abort, escalate the problem.
1004 ABORT The port has been seized by a user for a valid call.
Determine whether the port is available for testing.
1. Retry the command at one minute intervals a
maximum of five times.
2. If the test continues to abort, escalate the problem.
Table 10-260. TEST #96 Modem Pool NPE Crosstalk Test — Continued
Error
Code
Test
Result Description/ Recommendation
Continued on next page