Filter
Top Products
DEFINITY Enterprise Communications Server Release 5
Maintenance and Test for R5vs/si
555-230-123
Issue 1
April 1997
Maintenance Object Repair Procedures
Page 10-1175PRI-CDR/SEC-CDR (PRI-CDR Link)
10
■ From a data channel on TN777 Network Control circuit pack to a data
extension where the CDR output device connects via the standard EIA
232C interface.
The data extension can be a PDM, MPDM, DTDM, or ADU. The PDM,
MPDM, and DTDM connect to a Digital Line Port of TN754 or TN754B
Digital Line circuit pack; ADU connects to a Data Line Port of TN726 Data
Link circuit pack.
NOTE:
In duplicated systems it is possible for a failure on one of the processor
circuit packs to bring down the CDR link even if it is the standby processor.
This problem can not be resolved by interchanging processors because
the CDR ports on each of the processor circuit packs are connected via
WIRE-OR.
CDR Link Maintenance does not cover the maintenance of the elements
composing the CDR physical link, which are as follows:
■ External CDR output device
■ EIA port on Processor circuit pack
■ Data Module (PDM/MPDM/DTDM) and Digital Line Port of TN754 or
TN754B Digital Line circuit pack
■ ADU and Data Line Port of TN726 Data Link circuit pack
■ Data Channels on TN777 Network Control circuit pack
If CDR Link Maintenance cannot restore the CDR link, then the maintenance tests
of these individual components of the CDR link must be executed to diagnose
faults.
Procedures for Restoring the CDR Link
1. Get the status of CDR links.
Enter status cdr-link command and make sure that the CDR links are not
busied out for maintenance. If the link is down, then continue to the next
step.
2. Where does the CDR link connect to?
Enter display system feature and find out the destinations of CDR links.
Continue to the next step.
3. Is the destination an extension or the EIA port?
If the destination is an extension number, then enter the status data
extension command and verify whether the data extension is in the
in-service/idle state. If the data extension is NOT available, then look for