Filter
Top Products
DEFINITY Enterprise Communications Server Release 5
Maintenance and Test for R5vs/si
555-230-123
Issue 1
April 1997
Maintenance Commands and Trouble-Clearing Aids
Page 8-283release journal-printer
8
Command resources busy; Press CANCEL to clear, and then
resubmit
If all of the available maintenance resources are currently in use, then the
following message will be displayed:
All maintenance resources busy; try again later
Output
For the following output example, assume that the command that was entered is
"release journal-printer wakeup-log."
Feature Interactions
The maintenance of a particular component on a link will sometimes interfere with
the maintenance of the link itself. Maintenance can put a link component in a
busy state causing link set-up to fail. Frequent attempts at re-setup of a link may
delay the recover of a faulty component, due to the maintenance test of a
component only taking place when the component is idle. Therefore, the
technician needs to be able to disable the attempted re-setup of a link. The
busyout command is used to do this, and will not cause the link to be torn down.
If the link is already down, the busyout command will stop periodic re-setup
attempts on the link.
Port The port address (cabinet-carrier-slot-circuit) of the maintenance
object that is being busied out or released. In this case, the
physical object port address will be a 0 for wakeup log and a 1
for the pms log.
Maintenance Name The type of maintenance object that is being busied out or
released.
Alt. Name Not applicable.
Result An indicator as to whether the object was successfully busied out
or released.
Error Code A numerical description of why the command failed.
release journal-printer wakeup-log
COMMAND RESULTS
Port Maintenance Name Alt. Name Result Error Code
0 JRNL-LINK PASS
Command successfully completed