Filter
Top Products
DEFINITY Enterprise Communications Server Release 5
Maintenance and Test for R5vs/si
555-230-123
Issue 1
April 1997
Maintenance Object Repair Procedures
Page 10-1048PI-BD (Processor Interface Circuit Pack)
10
The system tries to restore the circuit pack within 15 minutes. If the error
recurs after 15 minutes, replace the circuit pack. (Refer to the "Handling
Control Circuit Packs" section in Chapter 5, ‘‘
Routine Maintenance
Procedures’’.)
k. Error type 3999
Indicates that the circuit pack sent a large number of
control channel messages to the switch within a short period of time. If
error type 1538 is also present, then the circuit pack was taken
out-of-service due to hyperactivity. If error type 1538 is not present, then
the circuit pack has not been taken out-of-service, but it has generated
50% of the messages necessary to be considered hyperactive. This may
be completely normal during heavy traffic periods. However, if this error
type is logged when the circuit pack is being lightly used, it may indicate a
problem with the circuit pack or the equipment attached to it.
System Technician Demanded Tests:
Descriptions and Error Codes
Always investigate tests in the order presented in the table below when
inspecting errors in the system. By clearing error codes associated with the
Standby Processor Interface Circuit Pack Test,
for example, you may also clear
errors generated from other tests in the testing sequence.
Note:
a. This test is repeated up to four times since there are four ports on the
circuit pack. Cross-reference PI-PT (Processor Interface Port)
Maintenance documentation for information about these tests.
Control Channel Loop Around Test (#52)
Refer to the repair procedure described in the XXX-BD (Common Port Circuit
Pack) Maintenance documentation as Control Channel Loop Around Test (#52).
1. D = Destructive; ND = Nondestructive
Order of Investigation
Short Test
Sequence
Long Test
Sequence D/ND
1
Standby Processor Interface Circuit Pack Test (#423) X X ND
Standby Processor Interface Port Test (#404) (a) X X ND
Control Channel Loop Test (#52) X X ND
NPE Audit Test (#50) X ND