Filter
Top Products
DEFINITY Enterprise Communications Server Release 5
Maintenance and Test for R5vs/si
555-230-123
Issue 1
April 1997
Maintenance Object Repair Procedures
Page 10-605DTMR-PT [Dual Tone Multifrequency Port (TTR)]
10
Tone Detector Audit/Update Test (#43)
The DTMR port is refreshed with all time slot information and sanity audit is
performed on the DTMR port.
2000 ABORT Response to the test request was not received within the
allowable time period.
2100 ABORT Could not allocate the necessary system resources to
run this test.
1. Retry the command at one-minute intervals a
maximum of five times.
2. If the test continues to abort, escalate the problem.
2006 ABORT DTMF detection failed. This could be caused by the
administered companding mode of the system not
matching that of the Tone Detector circuit pack.
1. Make sure that companding mode of the system
matches that of the Tone Detector.
2. If the test continues to abort, escalate the problem.
1-3 FAIL DTMF digits were not correctly detected.
1. Run the Short Test Sequence: test port PCSSpp sh
r 1.
2. If the problem persists, the system is still operating
properly but system capacity will be reduced. In
order to restore the system performance to normal,
replace the Tone Detector circuit pack containing
the defective DTMR port.
PASS The DTMR port is able to detect all the touch-tone digits.
Table 10-168. TEST #42 Tone Detection Verification Test — Continued
Error
Code
Test
Result Description/ Recommendation
Continued on next page