Filter
Top Products
DEFINITY Enterprise Communications Server Release 5
Maintenance and Test for R5vs/si
555-230-123
Issue 1
April 1997
Maintenance Commands and Trouble-Clearing Aids
Page 8-93disable synchronization-switch
8
Defaults
No defaults.
Parameters
None.
Help Messages
If the system technician presses help after entering "disable synchronization" the
following message will be displayed:
Entry is not required
Error Messages
If the command entered is in conflict with another currently executing command,
then a message will be displayed showing the login id of the conflicting user and
the conflicting command. The message is as follows:
’login id’:’command’ has a command conflict
If during the execution of a command a resource problem occurs that requires
the user to restart the command, then the following message will be displayed:
Command resources busy; Press CANCEL to clear,and then resubmit
If all of the available maintenance resources are currently in use, then the
following message will be displayed:
All maintenance resources busy; try again later
Output
If the disable synchronization command is successful, the following message will
be displayed on the SAT:
Command successfully completed
If the disable synchronization command is unsuccessful, the following message
will be displayed on the SAT:
Error encountered, can’t complete request
If the disable command is run and synchronization is currently disabled, the
following message will be displayed on the SAT:
Synchronization-switch already disabled
Feature Interactions
None.