Filter
Top Products
DEFINITY Enterprise Communications Server Release 5
Maintenance and Test for R5vs/si
555-230-123
Issue 1
April 1997
Maintenance Object Repair Procedures
Page 10-812ISDN-SGR (ISDN-PRI Signaling Group)
10
Figure 10-55. PRI Over PACON Remote Layer 3 Query (Test #637)
Table 10-225. TEST #637 Remote Layer 3 Query
Error
Code
Test
Result Description/Recommendation
ABORT Internal system error
1. Retry the command at 1-minute intervals a maximum of 5 times.
1006 ABORT This is a NORMAL ABORT. For country protocol 1 interfaces
(including the USA), either there are no B-channels administered in
this signaling group, or all B-channels in this signaling group are
either out-of-service or are in a "pending" state (PINS or PMTC,
indicating that a B-channel maintenance message for that
B-channel has been sent and not yet acknowledged).
1. Administer an ISDN Trunk or PRI Endpoint Port (B-channel) in
this signaling group, or use the status trunk TRK-GRP/TRK or
status pri-endpoint <extension> command to check the state
of the ISDN Trunks or PRI Endpoint Ports associated with this
signaling group. Refer to ISDN-TRK or PE-BCHL for further
details regarding service state definitions and transitions. For
systems not using country protocol 1 interfaces, there are no
B-channels administered in this signaling group.
1019 ABORT There is already a Remote Layer 3 Query in progress. This is a
normal ABORT.
1. Wait two minutes, then follow the procedures for when this test
passes.
Continued on next page
Packet Bus
To far end
sw itch hardware
Processor
(TN 786)
Packet
Control
Circuit
Pack
(TN 778)
UDS1
Interface
Circuit
Pack
(TN 464*)
*TN464 C or later