Filter
Top Products
DEFINITY Enterprise Communications Server Release 5
Maintenance and Test for R5vs/si
555-230-123
Issue 1
April 1997
Maintenance Object Repair Procedures
Page 10-1479TIE-TRK (Tie Trunk)
10
2012 ABORT An internal software error occurred.
1. Retry the command at 1 minute intervals for a
maximum of 5 retries.
2. If the test continues to abort escalate the problem.
2053 ABORT The test call could not be established, but no information
on why is available.
1. Retry the command at 1 minute intervals for a
maximum of 5 retries.
2. If the test continues to abort escalate the problem.
2056 ABORT An error occurred while trying to obtain results from the
TN771 circuit pack.
1. Test the TN771 circuit packs.
2. If the test continues to abort escalate the problem.
FAIL Measured transmission performance was in the
unacceptable range as administered on the trunk group
form. Retrieve a measurement report via the list
testcalls command. Make sure that ATMS thresholds
are set properly on page 4 of the trunk group form.
Besides the facility, test failures can be caused by faulty
test lines or switch paths. If the measurements point to a
facility problem, report the results to the trunk vendor.
8000 FAIL Measured transmission performance was in the
marginal range as administered on the trunk group form.
This generally means that the trunk is usable but has an
undesirable amount of noise or loss. If the user does not
report unacceptable effects, it may not be necessary to
take any action. Retrieve a measurement report via the
list testcalls command. Make sure that ATMS
thresholds are set properly on page 4 of the trunk group
form.
Table 10-447. TEST #844-848 Transmission Test — Continued
Error
Code
Test
Result Description/ Recommendation
Continued on next page