Filter
Top Products
DEFINITY Enterprise Communications Server Release 5
Maintenance and Test for R5vs/si
555-230-123
Issue 1
April 1997
Maintenance Object Repair Procedures
Page 10-700EXP-INTF (Expansion Interface Circuit Pack)
10
1144 ABORT The Packet Bus in the PPN has a major alarm active against it.
1. Resolve the alarm in the PPN.
2. Retry the command.
1195 ABORT An EI link switched during this test.
1. Retry the command at one minute intervals a maximum of 3 times.
1421 ABORT This abort code is valid and can appear only when the Expansion
Interface circuit pack addressed in the test command is one which
terminates the link between two the EPNs. It indicates that the test
failed, but that this test was run on the EPN EI circuit pack that:
a. is in the same EPN as the circuit pack under test,
b. is on the active link and
c. terminates the fiber from the PPN.
The EI tested is probably not at fault.
1. Enter display alarms and follow the EXP-INTF repair procedures
for the EPN EI that:
a. is in the same EPN as the circuit pack just tested here
b. is on the active link, and
c. terminates the fiber from the PPN.
2. If there are no alarms logged against that EI, run Test #589 on it
and follow procedures for this test.
3. Try this command again.
2060 ABORT The link on the Packet Bus that is being used to perform the test has
failed.
1. Retry the command at 1-minute intervals a maximum of 5 times.
2. If the test continues to abort, check for problems with the Packet
Control circuit pack (look for PKT-CTL errors).
2100 ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals a maximum of 3 times.
Table 10-198. TEST #589 Expansion Interface Packet Interface Test
— Continued
Error
Code
Test
Result Description/ Recommendation
Continued on next page