Filter
Top Products
DEFINITY Enterprise Communications Server Release 5
Maintenance and Test for R5vs/si
555-230-123
Issue 1
April 1997
Maintenance Object Repair Procedures
Page 10-1369TAPE (Tape Unit) [G3iV1.1-286]
10
Figure 10-90. Front View of the Tape Drive
To position the tape drive head properly for cleaning, do the following:
1. Install a tape cartridge into the drive with the power on.
2. Wait 10 seconds or until the spinning of the tape stops.
3. Remove the tape cartridge.
!
CAUTION:
The tape drive head should be cleaned by using only Freon TF and
polyurethane swabs. These products are usually available in VCR
head cleaning kits sold in video stores.
4. Wet the swab with the Freon TF solution.
5. Using a "side-to-side" motion, wipe the tape drive head.
TAPE DRIVE HEAD
CLEANING MOTION
CAPSTAN
PUSH BACK
THE TAPE
ACCESS DOOR
YELLOW LED