Filter
Top Products
DEFINITY Enterprise Communications Server Release 5
Maintenance and Test for R5vs/si
555-230-123
Issue 1
April 1997
Maintenance Commands and Trouble-Clearing Aids
Page 8-341save translation
8
Permissions
The following default logins may execute this command: system technician,
inads, init, cust.
Examples
save translation
save translation spe-active
save translation spe-standby
Description
All translation data is dept in memory during system operation. This means that
all data would be lost if the switch went down. The save translation operation will
allow the user to save to tape or memory card the in-memory translation data.
This operation may be done as part of scheduled maintenance and/or on
demand by the customer/system technician.
Simplex
The default is to save translation to the tape/memory-card on SPE_A.
Duplex
The default is to save translation to the tape/memory-card on both SPE-A and
SPE-B.
Parameters
Help Messages
If the system technician presses HELP after entering "save translation" the
following message will be displayed:
Enter [’spe-active’ or ’spe-standby’]
Error Messages
If there is another tape activity currently running on the system, then the following
message will be displayed:
A tape command is active;
spe-active This identifies that the save translation should be done on the active
processor’s MSS device.
spe-standby This identifies that the save translation should be done on the standby
processor’s MSS device.