Filter
Top Products
DEFINITY Enterprise Communications Server Release 5
Maintenance and Test for R5vs/si
555-230-123
Issue 1
April 1997
Maintenance Commands and Trouble-Clearing Aids
Page 8-382status audits
8
Parameters
Help Messages
If the technician presses HELP after entering "status audits," the following
message will be displayed:
cumulative peak-hour
Error Messages
If the "print" option is specified and there is no printer attached to the terminal or if
the printer is off line, then the following message will be displayed:
Printer failed
If during the execution of a command a resource problem occurs that requires
the user to restart the command, then the following message will be displayed:
Command resources busy;
Press CANCEL to clear, and then resubmit
If all of the available maintenance resources are currently in use, then the
following message will be displayed:
All maintenance resources busy; try again later
cumulative This option will display the data collected since the last reboot or since
the last execution of the "clear audits cumulative" command.
peak-hour This option will display the data for the peak hour since the last reboot,
or since the last execution of the "clear audits cumulative" or "clear
audits peak-hour" command. The peak hour is determined by
summing, for all audits, the number of times that the audit found and
fixed a problem, the number of times that the audit found a problem
that it could not fix and the number of times the audit aborted. The data
for the hour with the highest number is displayed as the peak hour’s
data. If two peaks of the same size occur, the most recent is displayed.
print If specified, this parameter will cause the information displayed by this
command to be sent to the printer attached to the terminal as well as to
the screen.
schedule When the "schedule" option is specified, the command is validated and
then a scheduling form is displayed to allow the technician to schedule
execution of the command. The command is then placed in the
command queue and is executed at the specified time. The information
displayed by the command is sent to the system printer instead of the
screen. Refer to the Report Scheduler and System Printer feature
specification [3] for more details.