Lucent Technologies R5SI Computer Hardware User Manual


  Open as PDF
of 2643
 
DEFINITY Enterprise Communications Server Release 5
Maintenance and Test for R5vs/si
555-230-123
Issue 1
April 1997
Maintenance Object Repair Procedures
Page 10-443DID-TRK (DID Trunk)
10
DID-TRK (DID Trunk)
Direct Inward Dial (DID) trunks, coming from the Central Office (CO), allow
outside parties to call directly to an extension in the system. DID Trunk circuit
packs include:
The DID Trunk circuit packs support eight, incoming-only, ports. Each port
provides an interface between the 2-wire analog line from the CO and the
DEFINITY system. The DID port receives 3 to 5 digits from the CO that is used to
directly connect an outside caller to the called station without assistance from an
attendant. See Figure 10-25.
1. Where P is the port network number (1 for PPN and 2 or 3 for EPN); C is the carrier
designation (for example, A, B, C, D, or E); and SS is the address of the slot in the carrier
where the circuit pack is located (for example, 01, 02, ..., etc.).
2. A MAJOR alarm on a trunk indicates that alarms on these trunks are not downgraded by
the set options command and that at least 75 percent of the trunks in this trunk group
are alarmed.
MO Name As
It Appears in
Alarm Log Alarm Level
Initial System
Technician
Command to Run
1
Full Name of MO
DID-TRK MAJOR
2
test port PCSSpp l DID Trunk
DID-TRK MINOR test port PCSSpp l DID Trunk
DID-TRK WARNING test port PCSSpp l DID Trunk
TN753 [G1, G3iV1.1-286, G3iV2-386] United States
TN2146 [G3iV2-386] Belgium and the Netherlands
TN2139 [G3iV2-386] Italy
TN 436 [G3iV2-386] Australia
TN459 [G3iV2-386] United Kingdom