Filter
Top Products
DEFINITY Enterprise Communications Server Release 5
Maintenance and Test for R5vs/si
555-230-123
Issue 1
April 1997
Routine Maintenance Procedures
Page 5-18System Backup
5
Response:
Test the 12-volt power supply by entering the test card-mem
command from the terminal. Executing this command causes the system
to run Test 701 (12 Volt Power Supply Test). If the power supply test fails,
replace the Netcon circuit pack. Then repeat whichever command failed.
3. Invalid directory on Card-Mem — The translation card needs
refreshing. Run test card-mem and be sure all tests pass.
4. Card-Mem is unusable — Something is wrong with the translation
card. Replace the translation card.
5. Could not write to Card-Mem — Something is wrong with the
translation card. Test the translation card.
6. Cannot access mass storage system now; try again later
— The storage system is in use. Try again later.
7. Request is incompatible with currently running
operations — The storage system is in use. Try again later.
8. Card-Mem is not inserted in the system — Insert the translation
card.
9. Cannot access file; wrong type of Card-Mem is inserted
— The correct translation card for the desired operation has not been
inserted. Load the appropriate translation card.
10. File size exceeded — There is no more file space. Call your Lucent
Technologies representative.
11. Upgrade Memory Card inserted — The system upgrade translation
card may have been inserted instead of the translations card. Insert the
translation card.
12. Card-Mem is write-protected — The switch on the top side of the
translation card is incorrectly set. Move the switch to the down position.
13. Transmission problem; please try later — There is a problem
communicating with the announcement circuit pack. Check to see that the
announcement circuit pack has been correctly administered. Use the
change data <extension_number> command. Verify that the
announcement circuit pack is in the correct slot in the processor. If so,
wait and retry.
14. Command has been aborted; please try later — The command
was pre-empted. Try again later.
15. Saved copy of translations is unusable — The copy of the
translations on your translation card is faulty. Re-enter the save
translation command.