Filter
Top Products
DEFINITY Enterprise Communications Server Release 5
Maintenance and Test for R5vs/si
555-230-123
Issue 1
April 1997
Maintenance Commands and Trouble-Clearing Aids
Page 8-308release tdm
8
Defaults
No defaults.
Help Messages
If the system technician presses HELP after entering "release tdm," the following
message will be displayed:
Enter ’port-network’, port network number (1-3),
’bus’, bus (’a’ or ’b’)
Error Messages
If the technician enters "bus" before "port-network," the following message will be
displayed:
’bus’ is an invalid identifier; please press
HELP
If the technician does not enter all digits for the port-network number, the
following message will be displayed:
Entry must be all digits
If the technician enters a bus other than A or B, the following message will be
displayed:
Identifier invalid
If the technician enters a TDM bus identifier with a Port Network number that is
not administered, the following message will be displayed:
Port Network number not assigned
If the port network on which the desired TDM bus resides is unavailable, the
following message will be displayed:
EPN is not available
If the command entered is in conflict with another currently executing command,
then a message will be displayed showing the login id of the conflicting user and
the conflicting command. The message is as follows:
pn number The PN number specifies the Port Network number of the TDM bus to
be released.
bus The TDM bus ("a" or "b") specifies which half of the TDM bus is desired.
Each 512 time slot TDM bus is configured as two duplicate 256 time
slot buses. This division allows for duplication of control channels and
dedicated tone time slots. The default control bus (carrying the control
channel) is the "a" bus, while the default tone bus (carrying dedicated
tones) is the "b" bus. A port network number (1 - 3) may be entered
with or without a leading zero (0).