Filter
Top Products
DEFINITY Enterprise Communications Server Release 5
Maintenance and Test for R5vs/si
555-230-123
Issue 1
April 1997
Routine Maintenance Procedures
Page 5-44System Features
5
NOTE:
The Feature Access Code (FAC) is administered on the Feature
Access Codes Form. The 197 FAC code used here is an example.
2. Dial port network number (1 for PPN or 2 or 3 for EPN), then dial ** and
listen for the following tones:
■ Confirmation Tone—Connection is made. Go to Step 3.
■ Reorder Tone—No time slots are out-of-service.
3. Repeat from Step 1 to alternate between out-of-service time slots on TDM
Bus A and B.
System Tone Test Call
The system tone test call connects the voice terminal user to a specific system
tone. To place the call:
1. Dial the Facility Test Call Feature Access Code (for instance, 197, see
Note), and listen for dial tone.
NOTE:
The Facility Test Call Access Code (FAC) is administered on the
Feature Access Codes Form. The 197 FAC code used here is an
example.
2. Dial port network number (1 for PPN or 2 or 3 for EPN), then dial
* followed
by the two-digit tone identification number listed in Table 5-3
.
3. Listen for the tone that was specified.
NOTE:
For a definition of Call Progress Tones see
DEFINITY Enterprise
Communications Server Release 5.4 System Descriptions and
Specifications
.
Table 5-3. System Tone Identification Numbers
Number Description
00 Null tone
01 Dial tone
02 Reorder tone
03 Alert tone
04 Busy tone
Continued on next page