Filter
Top Products
DEFINITY Enterprise Communications Server Release 5
Maintenance and Test for R5vs/si
555-230-123
Issue 1
April 1997
Maintenance Commands and Trouble-Clearing Aids
Page 8-513status system
8
completed assuming there are no faults in the standby SPE complex. The
active SPE could be either active or selected when the standby SPE is in
one of the Maintenance modes.
■ maint/init The standby SPE is in maintenance mode because the
system has restarted within the last 10 minutes. During this 10
minute interval, the standby SPE is not placed into standby mode
just in case a core dump is being written to the tape or memory
card on the standby SPE.
■ maint/idle This standby SPE is in maintenance mode, however no
maintenance activity is currently taking place. The active SPE could
be either active or selected.
■ maint/entering This standby SPE is currently in the process of
restarting the switch software on this SPE. As soon as the switch
software on this SPE finishes its initialization, the standby SPE will
be ready to perform SAT requested maintenance function and the
mode will change.
■ maint/testing This standby SPE is in maintenance mode executing
a SAT demanded test command.
■ maint/not-refreshed This standby SPE is in maintenance mode
executing a destructive background maintenance test that has
temporarily left the standby memory not refreshed. Once the
current test has completed a refresh of the standby SPE will be
performed by background maintenance and the mode will change.
■ maint/not-tested This standby SPE is in maintenance mode
because previously the active SPE had been selected with the SPE
select switches and since the active was unselected the standby
has not been tested to ensure the standby can enter standby
mode. Once the standby is tested successfully, the standby will go
back to standby mode.
■ maint/list-config This standby SPE is in maintenance mode and is
currently in the process of executing a SAT demanded list
configuration command.
■ maint/save~trans This standby SPE is in maintenance mode and is
currently in the process of executing a SAT demanded save
translation command.
■ maint/save~announce This standby SPE is in maintenance mode
and is currently in the process of executing a SAT demanded save
announcement command.
■ maint/status This standby SPE is in maintenance mode and is
currently in the process of executing a SAT demanded status
card-mem command.
■ maint/patching This standby SPE is in maintenance mode and is
currently in the process of applying a software patch to the standby
SPE memory.