Filter
Top Products
DEFINITY Enterprise Communications Server Release 5
Maintenance and Test for R5vs/si
555-230-123
Issue 1
April 1997
Maintenance Object Repair Procedures
Page 10-177BRI-PORT (ISDN-BRI Port), ABRI-PORT (ASAI ISDN-BRI Port)
10
Table 10-58. TEST #621 Level 1 Status Inquiry
Error
Code
Test
Result Description/ Recommendation
1187 ABORT The board, port or station may have been busied out by
a technician.
1. Look in the Error Log for Error Type 18 (port busied
out) for this port and BRI-BD (board busied out). If
this error type is present for BRI-PORT only, then
release the port via the release port pp command
and run the test again. If the error is present for both
BRI-BD and BRI-PORT, then release the board via
the release port PCSS command and run the test
again.
NOTE:
When you release a port, you release all ports
associated with it. If certain ports still need to be
busied out, use the release port PCSSpp
command to busy them out.
2. Make sure the terminal is connected.
3. Retry the command at one-minute intervals a
maximum of five times.
4. If the test continues to abort, escalate the problem.
2000 ABORT Response to the test was not received from the circuit
pack within the allowable time period.
1. If the test aborts repeatedly a maximum of five times,
reset the circuit pack via the busyout board PCSS
and reset board PCSS commands.
2. If the test aborts again, replace the circuit pack.
2012 ABORT Internal System Error.
2100 ABORT Could not allocate the necessary system resources to
run this test.
1. Retry the command at one-minute intervals a
maximum of five times.
2. If the test continues to fail, escalate the problem.
Continued on next page