Lucent Technologies R5SI Computer Hardware User Manual


  Open as PDF
of 2643
 
DEFINITY Enterprise Communications Server Release 5
Maintenance and Test for R5vs/si
555-230-123
Issue 1
April 1997
Maintenance Object Repair Procedures
Page 10-1225S-SYN-PT (Speech Synthesis Port)
10
Speech Synthesis Parameter Update Test (#169)
This test updates the DTMF interdigit time-out parameter used by the Speech
Synthesis circuit pack to be consistent with that specified by the switch
processing element (SPE).
Table 10-382. TEST #169 Speech Synthesis Parameter Update Test
Error
Code
Test
Result Description/ Recommendation
ABORT Could not allocate the necessary system resources to
run this test.
1. Retry the command at one-minute intervals a
maximum of five times.
2. If the test continues to abort, escalate the problem.
1000 ABORT System resources required to run this test are not
available. The port may be busy with a valid call and
therefore unavailable for certain tests. You must wait
until the port is idle (yellow LED if off) before retesting.
1. If the port is idle, retry the command at one-minute
intervals a maximum of five times.
2. If the test continues to abort, escalate the problem.
2100 ABORT Could not allocate the necessary system resources to
run this test.
1. Retry the command at one-minute intervals a
maximum of five times.
2. If the test continues to abort, escalate the problem.
Any FAIL An internal system error has occurred.
1. If the test continues to fail, escalate the problem.
PASS The DTMF interdigit time-out parameter has been
updated.
1. User-reported troubles should be investigated using
other tests and by verifying that other ports on this
circuit pack are working correctly.
Continued on next page