Filter
Top Products
DEFINITY Enterprise Communications Server Release 5
Maintenance and Test for R5vs/si
555-230-123
Issue 1
April 1997
Maintenance Object Repair Procedures
Page 10-208BRI-SET, ASAI-ADJ, BRI-DAT
10
2068 ABORT The endpoint has rejected the switch sent application
message. This indicates that the endpoint does not
support the ISDN-BRI Management and Maintenance
Procedure for Loop Back Testing.
1. Use the change station extension command and
change the MIMs Supported field to "no."
2069 ABORT The endpoint has returned an error response to the
application message sent by the switch.
2100 ABORT Could not allocate the necessary system resources to
run this test.
1. Retry the command at one-minute intervals a
maximum of five times.
2. If the test continues to abort, escalate the problem.
2000 FAIL No loop back activation or deactivation response is
received from the endpoint.
1. Consult the endpoint documentation to determine if
ISDN-BRI Management and Maintenance
Procedures are supported. If not supported, use
change station extension command to change the
MIMs Supported? field to "no." Use the busyout
station extension and release station extension
commands to busyout and release the endpoint to
resolve any endpoint alarms resulting from failure of
this test.
2. If the endpoint supports these procedures and the
test continues to fail, assume the endpoint is
defective and replace it.
2071 FAIL No data is detected on Channel B1 during loop back.
2072 FAIL No data is detected on Channel B2 during loop back.
1. Replace the endpoint and repeat test.
2. If test continues to fail, check the wiring between the
endpoint and the switch and repeat the test.
3. If test continues to fail, escalate the problem.
Table 10-67. TEST #627 BRI Remote Loop Back — Continued
Error
Code
Test
Result Description/ Recommendation
Continued on next page