Filter
Top Products
DEFINITY Enterprise Communications Server Release 5
Maintenance and Test for R5vs/si
555-230-123
Issue 1
April 1997
Maintenance Object Repair Procedures
Page 10-55ANL-16-L (16-Port Neon Analog Line)
10
Station Status and Translation Audits and
Updates Test (#36)
This test updates the Analog port’s message lamp state (if it has one) and
translations (such as station type, dial type, network connection) with information
kept in the software. The software is updated with the switchhook state reported
by the port processor. When the ringer is in the off state, this test also turns off
the station’s ringer to prevent constant ringing caused by defective hardware.
Table 10-23. TEST #36 Station Status and Translation Audits and Updates Test
Error
Code
Test
Result Description/ Recommendation
ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at one-minute intervals a maximum of five times.
1004 ABORT The port was seized by a valid call during the test. The test has been
aborted. Use the display port PCSSpp command to determine the station
extension. Use the status station command to determine the service state
of the port. If the service state indicates that the port is in use, then the port
is unavailable for certain tests. (Refer to the "Status Commands" section in
Chapter 8, "Maintenance Commands and Trouble-Clearing Aids", for a full
description of all possible states.) You must wait until the port is idle before
retesting.
1. Retry the command at one-minute intervals a maximum of five times.
2. If the test continues to abort and the port is not in use, escalate the
problem.
1005 ABORT The test was aborted due to a configuration problem. This test may not be
applicable, or it may be disruptive to terminal equipment other than a
voice terminal (for example, the modem pool member or music on hold).
1006 ABORT This port has been busied out by command, or taken out-of-service by the
failure of the NPE Crosstalk Test.
1. Look in the error log for error type 18 (port busied out) for this port. If
this error is present, release the port with the release station
extension command, and run the test again.
2. Look in the error log for error type 1025 (NPE crosstalk test failed) for
this port. If this error is present, investigate the errors associated with
the NPE Crosstalk Test 6.
3. Make sure that the terminal is connected and in service, and then
retest.
2000 ABORT Response to the test request was not received within the allowable time
period.
2100 ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at one-minute intervals a maximum of five times.
Continued on next page