Filter
Top Products
DEFINITY Enterprise Communications Server Release 5
Maintenance and Test for R5vs/si
555-230-123
Issue 1
April 1997
Maintenance Commands and Trouble-Clearing Aids
Page 8-86copy update-file
8
Description
In a Duplex system only, the copy update-file will copy a field update file from the
active SPE to the standby SPE. This command is intended to permit the user to
recover from situations whereby the standby SPE was not available when a field
update ("patch") file was downloaded to the switch. All validation checks are
made on the standby as it receives the file. If there is a newer, valid update file on
the standby, the override option must be used to force the copy.
Parameters
Help Messages
If the system technician presses HELP after entering "copy update-file" on a
duplex SPE system the following message is displayed:
[’override’]
Error Messages
If the standby SPE contains a newer patch file than the active SPE and the
override option was NOT used, the following message is displayed:
Active SPE’s update file is older than standby’s
If the vintage of the standby SPE doesn’t match the vintage of the active SPE, the
following message is displayed:
Update file vintage does not match standby SPE core vintage
If there is no update file on active processor, the following message is displayed:
No update file on tape
If the standby SPE is NOT in standby mode, the following message is displayed:
is displayed:
Cannot access the standby SPE at this time
If the active SPE cannot establish a communication path to the standby SPE, the
following message is displayed:
Could not establish netcon data call between SPE’s
If the command entered is in conflict with another currently executing command,
then a message will be displayed showing the login id of the conflicting user and
the conflicting command. The message is as follows:
’login id’:’command’ has a command conflict
override The override parameter allows the user to copy the update file
from the active SPE to the standby SPE regardless of the dates.