Filter
Top Products
DEFINITY Enterprise Communications Server Release 5
Maintenance and Test for R5vs/si
555-230-123
Issue 1
April 1997
Maintenance Commands and Trouble-Clearing Aids
Page 8-374status access-endpoint
8
other than access-endpoint
If the board that contains the access endpoint is not inserted in the system, the
following message will be displayed:
Board not inserted
If the EPN on which the access endpoint resides is not accessible, the following
message will be displayed:
EPN is not available
If during the execution of a command a resource problem occurs that requires
the user to restart the command, then the following message will be displayed:
Command resources busy;
Press CANCEL to clear, and then resubmit
If all of the available maintenance resources are currently in use, then the
following message will be displayed:
All maintenance resources busy; try again later
Output
For the following output example, the command "status access-endpoint 22502"
was entered. Assume that the access endpoint ports for extension 22502 are in
cabinet 1, carrier C, slot 11, circuit 1 to 6. The access endpoint is connected on
an active call to ports 7 to 12 of board in location 1B19 (cabinet 1, carrier B, slot
19). This means port 01C1101 is connected to 01B1907, port 01C1102 is
connected to 01B1908, port 01C1103 is connected to 01B1909, and so on.
Extension The extension of the access endpoint to be displayed.
(Starting) Port Port locations of the access endpoint. For wideband access endpoint,
the location shown is that of the starting port.
Communication
Type
The valid voice and data communication type that the access
endpoint is administered. The options are: 56k-data, 64k-data,
voice-grade-data, and wideband.
Width For communication types of 56k-data, 64k-data, and voice-grade
data, the width value is 1. For communication type of wideband, this
field displays the number of DS0s that makes up the access endpoint.
Service State Whether the access endpoint is in-service or out-of-service. One of the
following states displays: in-service/active, in-service/idle, and
out-of-service.
Connected
Ports
Port location connected to the access endpoint for an active call. For
wideband access endpoint connection, all ports connected to the
wideband access endpoint are listed.