Filter
Top Products
DEFINITY Enterprise Communications Server Release 5
Maintenance and Test for R5vs/si
555-230-123
Issue 1
April 1997
Maintenance Commands and Trouble-Clearing Aids
Page 8-175list configuration
8
■ Code — The TN or UN code and suffix of the circuit packs are displayed.
■ Vintage 00000000-065535 KKKKKK— The vintage number of the circuit
pack.
■ no board — The circuit pack is administered but not physically installed.
■ conflict — The circuit pack administered to the slot differs from the circuit
pack that is physically installed.
■ no link — The T1 link is down to a DS1 circuit pack.
Field definitions:
■ Signaling —This field is displayed only when "list configuration ds1"
option is selected. The contents of the field are the same as the signaling
mode administered for the ds1 circuit pack (via add/change ds1
command) or "none" if the circuit pack is not administered.
■ Name — This field is displayed only when "list configuration ds1" option is
selected. The contents of the field are the same as the name administered
for the ds1 circuit pack (via add/change ds1 command) or "blank" if the
circuit pack is not administered.
■ CSU MOD — This field is displayed only when "list configuration ds1"
option is selected. The field contains the identification number of the
Integrated CSU module present on the ds1 circuit pack (TN767E or later /
TN464F or later) or "none". If the circuit pack is a TN464E or TN767D,
"unknown" will be displayed. If the circuit pack is a TN464D or TN767C or
earlier suffix DS1 board, then "n/a" will be displayed.
Assigned Ports
Each port on the circuit pack is represented by a position corresponding to its
circuit number in ascending order from left to right. The assigned ports are not
displayed for "list configuration ds1". Two rows are required for circuit packs with
more then 8 ports. The position displays one of the following values depending
on its administered status:
■ 01-16 — The circuit number of an assigned port.
■ u — The port corresponding to this position exists but is unassigned.
■ t — The port is not currently assigned and is supported by the Terminal
Translation Initialization feature. Ports in this state can be activated by the
TTI association sequence.
Each port on a TN556 ISDN-BRI circuit pack can have two BRI endpoints. BRI
ports are displayed once when assigned only one endpoint and twice when fully
configured with two endpoints.