Filter
Top Products
DEFINITY Enterprise Communications Server Release 5
Maintenance and Test for R5vs/si
555-230-123
Issue 1
April 1997
Maintenance Commands and Trouble-Clearing Aids
Page 8-358set tdm
8
Description
The set tdm command sets which TDM bus on a port network has the control
channel and dedicated tones on it.
Defaults
No defaults.
Parameters
Help Messages
If the system technician presses HELP after entering "set tdm," the following
message will be displayed:
Enter ’port-network’, port network number (1-3),
’bus’, bus (’a’ or ’b’); [’override’]
Error Messages
If the technician enters "bus" before "port-network," the following message will be
displayed:
’bus’ is an invalid identifier; please press
HELP
If the technician does not enter all digits for the port-network number, the
following message will be displayed:
Entry must be all digits
If the technician enters a bus other than A or B, the following message will be
displayed:
Identifier invalid
If the technician enters a Port Network number that is not administered, the
following message will be displayed:
Port Network number not assigned
pn number The PN number specifies the Port Network number of the TDM bus to be set.
bus The TDM bus ("a" or "b") specifies which half of the TDM bus is desired. Each
512 time slot TDM bus is configured as two duplicate 256 time slot buses.
This division allows for duplication of control channels and dedicated tone
time slots. The default control bus (carrying the control channel) is the "a"
bus, while the default tone bus (carrying dedicated tones) is the "b" bus. A
port network number (1 - 3) may be entered with or without a leading zero (0).
override This qualifier is optional, it will force the setting of a bus which is out of
service or a bus whose dedicated tone time slots are in use.