Lucent Technologies R5SI Computer Hardware User Manual


  Open as PDF
of 2643
 
DEFINITY Enterprise Communications Server Release 5
Maintenance and Test for R5vs/si
555-230-123
Issue 1
April 1997
Maintenance Object Repair Procedures
Page 10-250CARD-MEM (Memory Card)
10
System Technician-Demanded Tests:
Descriptions and Error Codes
Always investigate tests in the order presented in the table below. By clearing
error codes associated with the
Memory Card Insertion Test
for example, you
may also clear errors generated from other tests in the testing sequence.
Note:
a. Refer to 12V-PWR (12 Volt Power Supply) Maintenance documentation for
a description of this test.
Memory Card Erase/Write/Read Test (#693)
The purpose of this test, which is nondestructive, is to verify the erase, write, and
read operations. The test erases the backup copy of the translation file stored in
the memory card, and it verifies that the erase operation works. The test then
writes the primary copy of the translation file from the same memory card to the
erased flash segment, and it verifies that the translation file is written
successfully.
This test can be initiated through a system technician demanded test card-mem
long command, or it can be executed as part of a maintenance test sequence
when the save translation and save announcements operations fail. The test
and relevant applications (for example, saving translations, saving
announcements) cannot be executed at the same time.
1. D = Destructive; ND = Nondestructive
Order of Investigation
Short Test
Sequence
Long Test
Sequence
Reset Board
Sequence D/ND
1
12 Volt Power Supply Test (#701) (a) X X ND
Memory Card Insertion Test (#695) X X ND
Memory Card Format and Read Test (#696) X X ND
Memory Card Match Test (#697) X X ND
Memory Card Write-Protected Test (#698) X X ND
Memory Card Directory Recovery Test
(#699)
XX ND
Memory Card Translation Data Integrity
Test (#694)
XND
Memory Card Erase/Write/Read Test (#693) X ND