Filter
Top Products
DEFINITY Enterprise Communications Server Release 5
Maintenance and Test for R5vs/si
555-230-123
Issue 1
April 1997
Maintenance Object Repair Procedures
Page 10-680EXP-INTF (Expansion Interface Circuit Pack)
10
1003 ABORT The system could not allocate a tone receiver for the test. The system
may be oversized for the number of Tone Detectors present or some
Tone Detectors may be out-of-service.
1. Look for TTR-LEV errors in the Error Log. If present, refer to
TTR-LEV (TTR Level) Maintenance documentation. Even if there
are no TTR-LEV errors, there still may not be a Tone Detector
available on the network that contains the circuit pack being
tested. Verify that there is at least one Tone Detector on this
network. If there is not at least one Tone Detector, this test always
aborts for this Expansion Interface circuit pack. This does not
harm the system in any way.
NOTE:
G3 systems require that Tone Detector circuit packs (TN768)
must be of vintage "B" or newer. If older Tone Detector circuit
packs are installed in the system, this test well always abort
with this abort code.
2. Look for TONE-PT errors in the Hardware Error Log. If present,
refer to TONE-PT (Tone Generator) Maintenance documentation.
3. If neither condition exists, retry the test at 1-minute intervals a
maximum of 5 times.
1033 ABORT The test cannot run because either one or both of the Expansion
Interface circuit packs on this link are busied out or an Expansion
Interface circuit pack is not present on the opposite end of the fiber.
1. If Expansion Interface is busied out, issue the release board
PCSS command.
2. Examine results of Tests #237 and #238.
2000 ABORT Response to the test request was not received within the allowable
time period.
2100 ABORT System resources required to run this test are not available.
1. Retry the command at 1-minute intervals a maximum of 3 retries.
Table 10-194. TEST #241 Expansion Interface 2-Way Transmission Test
— Continued
Error
Code
Test
Result Description/Recommendation
Continued on next page