Filter
Top Products
DEFINITY Enterprise Communications Server Release 5
Maintenance and Test for R5vs/si
555-230-123
Issue 1
April 1997
Maintenance Object Repair Procedures
Page 10-977M/T-DIG (Maintenance/Test Digital Port) [G3iV1-1.286, G3iV2-386]
10
Table 10-282. TEST #161 Loop Around Test
Error
Code
Test
Result Description/ Recommendation
1 ABORT Switch hook audit timed out. No response was received
from the circuit pack for information about the switch
hook state.
1. Retry the command at one-minute intervals a
maximum of five times.
2. If the test continues to abort, replace the circuit pack
and repeat the test.
3. If the test continues to abort, escalate the problem.
2100 ABORT System resources required to run this test are not
available.
1. Retry the command at one-minute intervals a
maximum of five times.
2. If the test continues to abort, escalate the problem.
Any FAIL Internal System Error. This test should never return a
failure.
1. Retry the command at one-minute intervals a
maximum of five times.
2. If the test continues to fail reset the circuit pack via
the busyout board PCSS, reset board PCSS,
release board PCSS command sequence.
3. Retry the command at one-minute intervals a
maximum of five times.
4. If the test continues to fail, escalate the problem.
PASS Call processing and Maintenance/Test Digital Port
maintenance software agree on the Maintenance/Test
Digital Port hook state.
Continued on next page