Filter
Top Products
DEFINITY Enterprise Communications Server Release 5
Maintenance and Test for R5vs/si
555-230-123
Issue 1
April 1997
Maintenance Object Repair Procedures
Page 10-1468TIE-TRK (Tie Trunk)
10
1004 ABORT (Non-TN497 circuit packs only.) The port was seized by
a valid call during the test. The test has been aborted.
Use the display trunk xx to determine the trunk
group/member number of the port. Use the status trunk
command to determine the service state of the port. If
the service state indicates that the port is in use, the port
is unavailable for certain tests. (Refer to the "Status
Commands" section in Chapter 8, ‘‘
Maintenance
Commands and Trouble-Clearing Aids’’ for a full
description of all possible states.) You must wait until the
port is idle before retesting.
1. Retry the command at one minute intervals a
maximum of five times.
2. If the test continues to abort, and the port is not in
use, escalate the problem.
1005 ABORT (Non-TN439 circuit packs only.) This test is not valid for
this trunk translation. For this test to run, a delay dial
trunk (or, for non-TN497 circuit packs, a wink-start trunk)
must be in effect, and the trunk must be outgoing or
two-way. Also, for the TN2140 [G3iV2-386], the trunk
must be continuous-seize-ack or
discontinuous-seize-ack.
1. Check trunk translation. If it is not a wink-start or
delay dial trunk, this abort message should be
ignored. (For the TN2140 [G3iV2-386], disregard
this abort on a trunk that is not continuous-seize-ack
or discontinuous-seize-ack.)
1018 ABORT Test disabled via administration.
1. Verify that the "Maintenance Tests?" field on the
Trunk Group Form is set to "n." To enable the test,
issue the change trunk-group x command where
"x" equals the number of the trunk group to be
tested. Then change the entry in the "Maintenance
Tests?" field on the form to "y."
Table 10-445. Seizure Tests (#73, #747, #73) — Continued
Error
Code
Test
Result Description/ Recommendation
Continued on next page